RingShot User Manual
Everything you need to install and configure the RingShot high-speed video analysis system. From first setup to advanced features, it's all here.
Quick Start Checklist
Follow these steps to get RingShot up and running for the first time:
-
Unpack & Connect Hardware
Mount the cameras, connect them to the framegrabber card, and place the TriggerPod sensor on the target.
-
Install RingShot Software
Run the installer on the provided system. The software is pre-configured for the included hardware.
-
Launch & Configure Cameras
Open RingShot, verify that all cameras appear in the viewport grid, and select your desired resolution/FPS mode.
-
Pair TriggerPod
Ensure the TriggerPod LoRa receiver is connected. The sensor pairs automatically when powered on.
-
Start Shooting
RingShot begins recording in ring-buffer mode. Shoot an arrow and the system triggers, replays, and resets automatically.
RingShot comes pre-installed on the provided hardware system. In most cases, you can skip to step 3.
Keyboard Shortcuts
Manual Chapters
Select a topic below to jump directly to the relevant documentation section.